Read or Download B-GL-371-015. Gun Drill, 105 mm Howitzer, LG1 MK II PDF
Similar technique books
Each web page of ShopNotes journal will make you a greater woodworker, since you get extra woodworking plans, extra woodworking strategies, extra woodworking jigs, and extra approximately woodworking instruments — and never a unmarried advert. For greater than 25 years, woodworkers have became to ShopNotes for the main particular woodworking plans and woodworking information on hand anyplace.
The three-volume set LNAI 3213, LNAI 3214, and LNAI 3215 constitutes the refereed lawsuits of the eighth foreign convention on Knowledge-Based clever info and Engineering structures, KES 2004, held in Wellington, New Zealand in September 2004. The over 450 papers offered have been rigorously reviewed and chosen from a variety of submissions.
This day the convergence of layout, engineering and architectural applied sciences are breeding a brand new fabric perform in experimental structure. during this pioneering ebook, this crucial shift is totally outlined as a hugely dynamic synthesis of rising rules of spatial, structural and fabric ordering built-in during the software of materialization and fabrication applied sciences.
- Woodworking Shopnotes 015 - Sliding Table
- Operation and Maintenance of Large Turbo-Generators (IEEE Press Series on Power Engineering)
- Handbook of Postharvest Technology: Cereals, Fruits, Vegetables, Tea, and Spices (Books in Soils, Plants, and the Environment, Volume 93)
- Krupp Trucks en Ruso
Additional info for B-GL-371-015. Gun Drill, 105 mm Howitzer, LG1 MK II
Ensure that the post is firmly planted and then steps clear. 5 “PICK UP” Both arms extended to the front and raised upwards. Pull the post out of the ground and await further signals. 6 “COME IN” Body turned in the direction required, both arms extended above the head and lowered in the direction required. When at the far post, double to the near post. When at the near post, double back to his or her position in action. Figure 2-4: Signals used by No 3 for Planting Aiming Posts 32. Drill: a. On the order “RECORD AT ,” No 1 will order “AIMING POSTS LEFT FRONT” (or RIGHT REAR).
11) Once the vehicle is clear, No 1 orders “SPREAD”. B-GL-371-015/FP-001 19 Gun Drill, 105 mm Howitzer, LG1 MK II c. (12) No 2 begins to pump until two distinctive clicks are heard from the trail locks. No 2 then replaces the pump handle in the stowing area. (13) No 1 orders “LOWER”. (14) No 3 removes the sight mount cover and installs the sight. No 3 ensures all scales are set to zero mils and levels the barrel. (15) No 2 removes the muzzle cover. (16) No 1 opens the breech. Positioning Stores and Ammunition: (1) Nos 4 and 5 remove the tool box from the vehicle and place it 5 metres in rear of the left trail.
Positioning Stores and Ammunition: (1) Nos 4 and 5 remove the tool box from the vehicle and place it 5 metres in rear of the left trail. (2) Nos 6 and 7 unload the stores and ammunition from the vehicle and place them in a convenient position in rear of the left trail. (3) No 1 signals the vehicle to DRIVE ON, and the vehicle proceeds to the vehicle area under supervision of the TSM. (4) No 5 lays the communication line and takes the gun marker to the CP. (5) No 4 prepares the collimator and aiming posts.